SHAFTS ANODES
SHAFT SIZES:
STANDARD MODELS X-1 TO X-26
FROM 3/4" TO 6 1/2"
METRIC MODELS MX-25 TO MX-150
FROM 25MM TO 150MM
*ALL SHAFT SIZES INCLUDE COPPER CONTACTS FOR PERMANENT GROUND AND STAINLESS SCREWS WITH WASHER RETAINERS
RUDDER/TRIM TAB ANODES
RUDDER SIZES:
DOUBLE PLATES
MODELS R-1 TO R-7
DIAMETER FROM 1 7/8' TO 6 1/2"
SINGLE PLATE
MODELS R-2S AND R-7S
DIAMETER 2 15/16" AND 6 1/2"
*ALL RUDDER ZINCS INCLUDE COPPER CONTACTS FOR PERMANENT GROUND AND A STAINLESS SCREW
TRIM TAB ZINCS FOR ITALIAN YACHTS
TWO HOLES WITH 3" CENTER TO CENTER
BOLT ON ANODES
BOLT ON ZINCS FOR TRANSOM AND HULL
ROUND ZINCS WITH SINGLE HOLE
DIAMETER FROM 3 15/16" TO 8 3/4"
RECTANGLE ZINCS WITH TWO HOLES
CENTER TO CENTER FROM 5" TO 15"
SEARAY ZINCS WITH C/C OF 5"
SUNSEEKER ZINCS WITH C/C OF 8" AND 9"
DIVER DREAM PLATES WITH SLOTS
ARNESON DRIVE ZINCS
KAMEWA JET DRIVE ZINCS
PROP NUT ANODES
PROPELLER ZINCS FOR:
- AZIMUT
- FERRETTI
- BENETTI
- WESTPORT
- SANLORENZO
- RIVA
- BENETEAU
BOW THRUSTER ANODES
BOW AND STERN THRUSTER ZINCS FOR:
- SIDE-POWER
- VETUS
- WESMAR
- BCS
- VOSPER
WELD ON ANODES
SINGLE STRAP ZINCS
OVERALL LENGHT FROM 4 3/8" TO 18 3/4
TEAR DROP ZINCS
OVERALL LENGHT 10" AND 12 1/2"
DOUBLE STRAP ZINCS
OVERALL LENGHT 10"
COLLAR ANODES
SHAFT SIZES:
STANDARD MODELS C-3 TO X-25
FROM 1" TO 6"
METRIC MODELS
*AVAILABLE UPON REQUEST
*ALL COLLAR SIZES INCLUDE COPPER CONTACTS FOR PERMANENT GROUND AND STAINLESS SCREWS WITH WASHER RETAINERS
WIRE ANODES
ZINCS FOR BOAT LIFT APPLICATIONS
THREE SIZES 3.8 LBS, 6.5LBS, AND 11LBS
10FT STAINLESS CABLE
TEAR DROP "GROUPER" ZINC
10FT STAINLESS CABLE WITH CLIP
ALL NEW PENCIL ZINCS!
ZIMAR'S PATENT PENDING PENCIL DESIGN IS MADE FROM SPECIAL HIGH GRADE ZINC THAT:
- PREVENTS ENGINE DAMAGE BY CORRODING AND DISSOLVING INTO SMALL PARTICLES THAT EASILY EXIT THROUGH THE EXHAUST SYSTEM
- WON'T EXPAND AND GET STUCK INSIDE THE ENGINE WHEN ITS TIME TO REPLACE
- IMPROVES CORROSION PROTECTION OVER COMPETITORS WITH INDIVIDUALLY HAND POURED ZINC PROCESS
- CAST-IN BRASS THREAD
- REUSABLE BRASS PLUG
CUSTOM ANODES
WITH A FULL SIZE MACHINE SHOP WE ARE ABLE TO MACHINE ZINCS FROM SMALL CUSTOM PENCIL ZINCS TO LARGE PROP NUT ZINCS